Rotax 915 i A series Maintenance Manual page 339

Hide thumbs Also See for 915 i A series:

Table of Contents

Figure 14.25

Ignition housing

Insertion jig

Install the ignition housing. See

24-20-00 section Internal

Push on the stainless compensating shim

and apply LOCTITE 243 to the thread of

the water pump shaft. Then fasten the im-

peller with the special tool part no.

877295 (with the crankshaft locked, see

relevant Maintenance Manual Line chap-

ter 12-20-00. Tightening torque 15 Nm

(133 in. lb.).

Ensure that the impeller runs true. If there is no-

ticeable runout, this, and possibly also the pump

shaft, must be replaced.

Effectivity: 915 i A Series

Edition 0/Rev. 0

MAINTENANCE MANUAL HEAVY

Figure 14.26: TYPICAL

WATER PUMP HOUSING — ASSEMBLY

Lubricate the new bent socket with LOC-

Screw the bent sockets at least 5 revolu-

tions into the water pump housing and po-

Usually, 3 bent sockets with a bend angle of 45°

and 1 bent sockets with a bend angle of 20° are

Washer 8.2/12.5/1.5

August 01 2018

Chapters

Table of Contents