Inspection Of Parts And Report Of Findings - Rotax 915 i A series Maintenance Manual

Hide thumbs Also See for 915 i A series:

Table of Contents

INSPECTION OF PARTS AND REPORT OF FINDINGS

General note

Measure all parts listed in the dimension sheets. These are attached directly after each

All measurements must be entered in the corresponding dimension sheets as shown.

Filling in the dimension sheets

Following the description how to fill in the dimension sheets.

If the engine is overhauled/repaired before the end of the TBO, the 50 % specified val-

Figure 1.2: EXAMPLE ONLY

• Look up the desired control point code (1) in the illustration in the specified section

• The maximum limits for wear are divided into the columns maximum wear 100 % (2)

• The first line (4) gives the maximum permissible value in [mm], the second line (5) in

Effectivity: 915 i A Series

Edition 0/Rev. 0

MAINTENANCE MANUAL HEAVY

ues for wear limits do not apply and must be calculated separately in accordance with

section "Classification of parts for maintenance/repair".

and 50 % wear (3)

August 01 2018

Table of Contents