Rotax 915 i A series Maintenance Manual page 378

Figure 16.12
Regulator B
1
Thread of the gasket screw connection
3
ATTENTION
When pressing in the gasket screw connec-
tion, avoid damaging the connecting thread.
Step Procedure
5 Pull all the cables 2 RED/WHITE (mark-
ing: B+) and 4 BLACK (marking: B and B-
) into the fuse box. The plastic insert must
be pressed completely into the connect-
ing thread of sealing union.
76–20–00
Page 10
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Cap nut of the gasket
2
screw connection
ATTENTION
Note the wire marking and labeling of the con-
necting bolts (labeled on the board of the fuse
box). All cables must be installed without
kinks.
ATTENTION
The ring terminals attached to the connecting
ports B-, B and B+ must not touch each other
(except those rings which are attached to the
same connection bolt).
Step Procedure
6 BLACK cable (2 pcs, labeled: B-) connect
to connection bolt B-. Fasten the cable
lug with locking nut M4 and washer on
the connection bolt.
The crimping of the lower cable lug must
be directed towards the board of fuse
box.
The crimping of the upper cable lug must
be directed toward the cover of the fuse
box Tightening torque: 1,2 Nm (11 in.lb).
Wrench size: A/F 7.
7
BLACK cable (2 pcs, labeled: B) connect
to connection bolt B. Fasten the cable lug
with locking nut M4 and washer on the
connection bolt.
The crimping of the lower cable lug must
be directed towards the board of fuse
box. The crimping of the upper cable lug
must be directed toward the cover of the
fuse box Tightening torque: 1,2 Nm (11
in.lb). Wrench size: A/F 7.
8 RED-WHITE cable (2 pcs, labeled: B+)
connect to connection bolt B+. Fasten the
cable lug with locking nut M5 and washer
on the connection bolt.
The crimping of the lower cable lug must
be directed towards the board of fuse
box. The crimping of the upper cable lug
must be directed toward the cover of the
fuse box Tightening torque: 2,2 Nm (19
in.lb). Wrench size: A/F 8.
Effectivity: 915 i A Series
Edition 0/Rev. 0