Throttle Body Assy. - Installation - Rotax 915 i A series Maintenance Manual

Step Procedure
2 Connect the wiring harness connector ap-
propriately. See
harness.
3 Fix the cover with 4 Allen screws.
Tightening torque 6 Nm (53 in. lb.)
4 Install the fuel line assy.
NOTE
The position and type of positioning and attach-
ment of the fuel pump depends on the aircraft
type. See aircraft manufacturer documentation.
Figure 11.76
1 Allen screws
3 Pressure line
THROTTLE BODY ASSY. —
INSTALLATION
NOTE
When the throttle body is installed, a new rubber
gasket ring must be used!
Step Procedure
1 Install the rubber gasket ring.
73–10–00
Page 42
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Chapter 76-50-00 Wiring
2 Intake system
NOTE
The rubber gasket ring is installed dry!
Figure 11.77
Throttle body assy.
1
Procedure
Step
2 Push the throttle body into the airbox. Se-
cure 3 hex./torx flange screws and fixa-
tion latch with LOCTITE 243.
Tightening torque 8 Nm (70 in. lb.).
Figure 11.78
Hex./torx flange
1
screws M6x16
Rubber gasket ring
2
2
Fixation latch
Effectivity: 915 i A Series
Edition 0/Rev. 0