Rotax 915 i A series Maintenance Manual page 375

Figure 16.7
Regulator plate
1
3 Lock nut M4
5 Lock nut M6
Step Procedure
8 Pull the 2 RED-WHITE and the 4 BLACK
cables with grommet out of the fuse box.
To pull out the cables easily, avoid bend-
ing the ring terminals.
NOTE
The connecting thread of sealing union must not
be dismantled, if you replace the regulator. An
exchange of this plastic insert is only necessary
if it is damaged.
Step Procedure
9 Remove the regulator.
NOTE
Be careful when handling the dismantled regula-
tor. On the back side of the regulator and the
regulator plate thermal paste can adhere.
REGULATOR A — REMOVAL
• The regulator A is removed analogously to regula-
tor B.
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Regulator B
2
4
Washer 4.3
6
Washer 6.4
ATTENTION
The pin assignment of the ground cable is dif-
ferent for regulator A and B.
NOTE
Wrench size of the gasket screw connection: A/
F 25.
76–20–00
Page 7
August 01 2018