Rotax 915 i A series Maintenance Manual page 338

ASSEMBLY
IGNITION HOUSING – ASSEMBLY
Oil seal – Installation
Step Procedure
1 Lubricate the outside of a new oil seal
and press it into the ignition housing as
far as the bottom with a suitable jig part
no. 876510.
Figure 14.23
1 Oil seal
Water pump shaft – Installation
Step Procedure
1 Apply small amount of LOCTITE 243 to
the inner diameter of the rotary seal and
press it into the insertion jig part no.
877258. Then press in the water pump
shaft as far as it will go.
2 Insert the pump gear in the ignition
housing.
75–00–00
Page 20
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Insertion jig
2
Figure 14.24
Insertion jig
1
Water pump shaft
3
Procedure
Step
3 Press the pump shaft with the rotary seal
into the ignition housing using the inser-
tion jig part no. 877258.
NOTE
Ensure that the pump gear is aligned with the
pump shaft.
NOTE
The spacing WP01 is automatically established
with insertion jig part no. 877258
Rotary seal
2
Effectivity: 915 i A Series
Edition 0/Rev. 0