Rotax 915 i A series Maintenance Manual page 408

FUSE BOX (FUSE BOX) — CONNECTION
The sensors are connected and disconnected in the
same way. See Chapter 76-50-00 section
AMBIENT PRESSURE SENSOR —
CONNECTION
The sensors are connected and disconnected in the
same way. See Chapter 76-50-00 section
STARTER RELAY — CONNECTION
The sensors are connected and disconnected in the
same way. See Chapter 76-50-00 section
Tightening torque 10 Nm (89 in. lb).
Please observe the instructions of the air-
craft manufacturer.
76–50–00
Page 24
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Removal.
Removal.
Removal.
PRESSURE CONTROL VALVE (PCV) –
CONNECTION
The sensors are connected and disconnected in the
same way. See Chapter
control valve (PCV) - disconnection.
GROUND CABLES – CONNECTION
For connection of the ground cables
please observe the instructions of the air-
craft manufacturer.
FINISHING WORK
• Check that all plug connections are secure, con-
tacted and free from corrosion and dirt
• Check the grounding for good contact and
cleanliness
Carry out an engine test run.
See Maintenance Manual Line for the en-
gine type 915 i A Series Chapter 12-20-00.
76-50-00 section Pressure
Effectivity: 915 i A Series
Edition 0/Rev. 0