Needle Bearing And Oil Inlet - Installation; Governor Drive - Installation; Governor Flange - Installation - Rotax 915 i A series Maintenance Manual

Step Procedure
4 Secure M5x12 countersunk screw includ-
ing the retaining washer with LOCTITE
243 and tighten it. Tightening torque 6
Nm (53 in.lb.)
Figure 3.15
M5x12 countersunk
1
screw
NEEDLE BEARING AND OIL INLET —
INSTALLATION
See Chapter 72-10-00 section Propeller
GOVERNOR DRIVE — INSTALLATION
Step Procedure
1 Place on the vacuum pump gear and fix
the lubricated drive sleeve with the retain-
ing tool part no. 242661.
2 Secure Allen screw M8x16 with LOCTITE
648 and tighten it.
Tightening torque 25 Nm (18 ft.lb).
61–20–00
Page 14
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Retaining washer
2
gearbox.
Figure 3.16
Retaining tool part no.
1
242661 and 876470
3 Allen screw M8x16
GOVERNOR FLANGE — INSTALLATION
Step Procedure
1 Install the governor flange including the
distance sleeve in the crankcase with a
new O-ring 32x4.
2 Place one O-ring 7x2 each in the oil inlet
flange and governor flange and hold them
in position with a little bit of grease.
2
Drive sleeve
Vacuum pump gear
4
Effectivity: 915 i A Series
Edition 0/Rev. 0