Installation; Fly Wheel Assy. - Installation; Ignition Housing Assy. - Installation - Rotax 915 i A series Maintenance Manual

INSTALLATION

FLY WHEEL ASSY. — INSTALLATION
Preparation
NOTE
Clean all flat surfaces
Procedure
Step
1
Apply a small thin layer of LOCTITE 648
to the flat surface of the sprag clutch
housing.
2 Place fly wheel on top.
3 Secure 6 Allen screws M6x12 (12.9
screw strength) with LOCTITE 603 and
tighten them. Tightening torque 18 Nm
(159 in. lb.).
Figure 2.37: TYPICAL
Fly wheel
1
IGNITION HOUSING ASSY. —
INSTALLATION
See Ignition housing screw diagram
Preparation
• Check whether dowel pin has been inserted
24–20–00
Page 20
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2
Allen screw M6x12
Figure 2.38: : TYPICAL
Dowel pin
1
Procedure
Step
1 Lubricate oil seal, bearing bushing and
crankshaft stub with Engine oil.
2 Insert O-ring 5x2 into the crankcase and
lubricate with Lithium-base grease to hold
in position.
Figure 2.39
1 Oil seal
3 Crankshaft stub
2 Bearing bushing
O-ring 5x2
4
Effectivity: 915 i A Series
Edition 0/Rev. 0