Rotax 915 i A series Maintenance Manual page 417

Step Procedure
3 Pull the respective connector of the wiring
harness out of the corresponding pres-
sure sensor (MAPS_1/MAPS_2). See
Chapter 76-50-00 section Wiring harness
(main strand).
4
Lift the latch and pull off.
5 Loosen the pressure sensor with an SW
21 open-ended spanner (or a similar tool)
and remove it.
6 Close the opening with the appropriate
protective plug.
Figure 18.6
1 Pressure sensor
OIL PRESSURE SENSOR (OPS) —
REMOVAL
Installation position: Ignition housing
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Step Procedure
1 Cut open the cable ties on the oil pres-
sure sensor.
2 Pull the respective connector of the wiring
harness out of the corresponding pres-
sure sensor (OPS).
See Chapter 76- 50-00 section Wiring
harness (main
3 Lift the latch and pull out the connector.
Figure 18.7
Oil pressure sensor
1
Step Procedure
4 Loosen the oil pressure sensor with an
SW 19 open-ended spanner part no.
876130 (or a similar tool) and remove it.
5
Close the threaded bore with the appro-
priate protective covering.
AMBIENT AIR PRESSURE/
TEMPERATURE SENSOR (AAPTS) —
REMOVAL
Installation position: Aircraft frame
strand).
2
Cable ties
76–70–00
Page 9
August 01 2018