Rotax 915 i A series Maintenance Manual page 422

Figure 18.18
1 Knock sensor
CRANKSHAFT POSITION SENSOR
ASSY. (CPS_1, CPS_2) — REMOVAL
Installation position: Ignition housing
Step Procedure
1 Unplug the respective connector of the
wiring harness (main strand) from the cor-
responding crankshaft position sensor
assy. See Chapter 76-50-00 section Wir-
ing harness (main
2 Remove cable ties. Lift the latch and pull
apart.
3 Pull the connector out of the support
plate.
76–70–00
Page 14
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2
Screw
strand).
Figure 18.19
Connector CPS_1
1
Support plate
3
Procedure
Step
4 Remove the Allen screw M6x50 and
washer with an Allen key 5 (or similar
tool) and remove the cable clamp.
NOTE
This screw is sealed with LOCTITE
243.
5 Loosen the Allen screw M6x20 and wash-
er and remove the crankshaft position
sensor assy.
6 Close the opening with the appropriate
protective plug.
Connector CPS_2
2
4
Cable ties
Effectivity: 915 i A Series
Edition 0/Rev. 0