Crankshaft Position Sensor Assy. (Cps_1/Cps_2) - Installation - Rotax 915 i A series Maintenance Manual

Part no. of con- Corresponding tool
nector set
866420 DEUTSCH HDT- 48 - 00
866422
Figure 2.35
1 Lock
Step Procedure
5 Install cable clamps 8/M6.
NOTE
The bends of the cable clamps must be installed
in a diametrically opposed manner (back to
back).
Step Procedure
6 Adjust cables. Tighten Allen screw
M6x20.
Tightening torque 10 Nm (89 in. lb.).
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Figure 2.36
1 Allen screw M6x20
Cable clamps 8/M6
3
CRANKSHAFT POSITION SENSOR
ASSY. (CPS_1/CPS_2) — INSTALLATION
To install the crankshaft position sensor see Chapter
76-70-00 section Crankshaft position sensor assy.
(CPS_1/CPS_2) — installation.
2
Lock washer M6
24–20–00
Page 19
August 01 2018