Fuel Line Assy. - Installation - Rotax 915 i A series Maintenance Manual

Step Procedure
5 Install double ignition coils, see Chapter
74-20-00 section Double ignition coil
installation.
6 Plug in the wiring harness connector ap-
propriately. See
Wiring harness.
7 Install fuel regulator reference hose.
FUEL LINE ASSY. — INSTALLATION
The fuel line is installed and removed in the same
way. The following should be noted.
ATTENTION
Install the fuel line assy. in a tension-free man-
ner. If the line is too far away from the fuel rail,
the fuel line must be adjusted. The sealing sur-
faces must be parallel.To be sure: The banjo
bolts must fit without twisting (fuel line) and
must be able to be hand tightened.
Step Procedure
1 Fix the fuel line assy. on the left and right
of the fuel rails with banjo bolts. Tighten-
ing torque 25 Nm (18 ft. lb.).
73–10–00
Page 44
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Chapter 76-50-00 section
Figure 11.82
Banjo bolt M12x1.5
1
Fuel hose assy.
3
Step Procedure
2 Secure the cable clamp 8/M6 with an Al-
len screw M6x16 and washer 6.4 to the
propeller gearbox with LOCTITE 243.
Tightening torque 10 Nm (89 in. lb.).
Figure 11.83
1 Allen screw M6x16
Cable clamp 8/M6
3
Gasket ring A12x18
2
2
Washer 6.4
Effectivity: 915 i A Series
Edition 0/Rev. 0