Rotax 915 i A series Maintenance Manual page 93

Figure 3.17: TYPICAL
1 Distance sleeve
O-ring 7x2
3
Step Procedure
3 Place on the governor flange, secure it
using LOCTITE 243 with 4 Allen screws
M6x20 on the crankcase and with 2 Allen
screws M6x16 on the oil inlet flange, and
tighten the screws. Tightening torque 10
Nm (89 in. lb.).
LOCTITE 5910 can be used on the seal-
ing surfaces of the governor flange.
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
O-ring 32x4
2
Figure 3.18
Governor flange
1
3 Allen screw M6x16
ATTENTION
Longer screws destroy the oil inlet flange.
Procedure
Step
4 Install the propeller gearbox. See
72-10-00 section
5 Install the governor pressure oil line on
the governor flange.
Tightening torque 17 Nm (150 in.lb.).
6 Install governor oil pressure oil line on the
oil pump.
Tightening torque 12 Nm (106 in.lb).
7 Fasten the governor pressure oil line with
the cable clamp using the hex. screw
M8x25 and LOCTITE 243.
Tightening torque 15 Nm (133 in.lb.).
2
Allen screw M6x20
Chapter
Gearbox.
61–20–00
Page 15
August 01 2018