Coolant Elbow - Installation; Valve Installation - Rotax 915 i A series Maintenance Manual

Step Procedure
2 Allow the elbow flange to harden for at
least 10 hours at room temperature.
NOTE
Remove excess LOCTITE.
Figure 8.36
1 Coolant elbow
COOLANT ELBOW — INSTALLATION
Step Procedure
1 Install a new O-ring 19x2 in the cylinder
head.
2 Fasten the coolant elbow with 2 Allen
screws M6x20 and lock washers 6.4.
Tightening torque 10 Nm (89 in. lb.).
NOTE
Install the cable brackets on cylinder 2/4.
72–30–00
Page 28
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2 Elbow flange
Figure 8.37
1 Screws M6x20
O-ring 19x2
3

VALVE INSTALLATION

ATTENTION
Risk of engine damage if damaged parts are in-
stalled! All parts must be measured and as-
sessed before installation. All moving parts
must be lubricated with engine oil before
installation!
ATTENTION
Oil residues up to max. 20% of the running sur-
face are permissible.
Step Procedure
1 Push 16/27.9/1 onto the valve guide and
install a new valve stem seal on the in-
take side.
2 Lubricate the valve stem and push the in-
take valve from outside into the valve
guide.
Elbow flange
2
Effectivity: 915 i A Series
Edition 0/Rev. 0