Rotax 915 i A series Maintenance Manual page 493

OIL PUMP — INSTALLATION
Preparation
• Check the fit of the O-rings on the oil pump
housing.
ATTENTION
Ensure that the oil pump shaft is in the correct
installation position.
Oil pump shaft
1
O-rings
3
Figure 22.24: TYPICAL
Step Procedure
1 Apply LOCTITE 5910 to the contact area
on the crankcase.
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2 Oil pump housing
Figure 22.25
1 Crankcase
Step Procedure
2 Install the oil pump housing with Allen
screws M6x50 and washers 6.4 cross-
wise and by hand. Then tighten the Allen
screws crosswise.
Tightening torque 10 Nm (89 in. lb.).
3 Tighten plug screw.
Tightening torque 30 Nm (22 ft. lb.).
4 Attach the safety wire.
Figure 22.26: TYPICAL
1 Allen screws M6x50
Plug screw M22x1.5
3
2
Washers 6.4
79–00–00
Page 17
August 01 2018