Fastener Information - Rotax 915 i A series Maintenance Manual

FASTENER INFORMATION

Self locking fasteners procedure
The following describes common procedures used when working with self-locking fasten-
ers (Hardware supplies with pre-applied adhesive).
Use a metal brush on the fastener threads or a tap to clean the hole properly, then use a
solvent. Allow the solvent time to act, then wipe off or blow out with shop air. Solvent uti-
lization is to ensure proper adhesion of the product used for locking the fastener.
Figure 1.4: Fastener Information
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
If not specified otherwise, the threads are not lubricated when fastened.
ATTENTION
00–00–00
Page 23
August 01 2018