Installation Of (2/4) And (1/3) Fuel Rails - Rotax 915 i A series Maintenance Manual

Figure 11.62
Outer screw-fastening
1
Figure 11.63
1-ear clamp
1
• Install double ignition coil. To do this, see Chapter
74–20–00 section Double ignition
73–10–00
Page 36
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Inner screw-fastening
2
2
Intake manifold
coil.
INSTALLATION OF (2/4) AND (1/3) FUEL
RAILS
The fuel rails (2/4) and (1/3) are installed and re-
moved in the same way. The following should be
noted.
Step Procedure
1 Lubricate the O-rings of the injectors
lightly with Lithium-base grease.
Figure 11.64
Injector
1
NOTE
When a used injector is reinstalled, new O-rings
must be installed, and the injector must be in-
serted by hand.
Step Procedure
2 Install the injectors and rubber dampers.
2 O-rings
Effectivity: 915 i A Series
Edition 0/Rev. 0