Rotax 915 i A series Maintenance Manual page 76

ATTENTION
The ignition housing must be attached man-
ually without tapping.
Figure 2.42: Ignition housing screw diagram
1 Allen screws M6x30
Ignition housing assy.
3
Step Procedure
7
Secure upper Allen screw M6x50 with
LOCTITE 243 and tighten it.
Tightening torque 10 Nm (89 in. lb.)
ATTENTION
Do not use a longer screw! The screw would
press on the cylinder sleeve and cause dam-
age to piston and cylinder.
NOTE
The through-bore of the Allen screw M6x50 pen-
etrates as far as the crankcase.
The engine is not leakproof if this screw is not
seated with LOCTITE 243.
24–20–00
Page 22
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2
Allen screws M6x50
Figure 2.43: TYPICAL
1 Allen screw M6x50
Cable clamp
3
ATTENTION
If the water pump is not installed straight away,
then 2 M6x65 temporary screws with washers
must be screwed in so that the sealing surface
is evenly clamped.
Figure 2.44
1 Allen screw M6x65
Step Procedure
8 Fasten hex. screws M5x45. Tightening
torque 5 Nm (44 in. lb.)
2
Washer A 6.4
2 Water pump wheel
Effectivity: 915 i A Series
Edition 0/Rev. 0