Rotax 915 i A series Maintenance Manual page 438

Figure 18.48
Temperature sensor
1
(OTS)
EXHAUST GAS TEMPERATURE
SENSOR (EGT1/EGT2/EGT3/EGT4) —
INSTALLATION
Procedure
Step
1 Carefully push the temperature sensor
(EGT) into the locking plate.
Figure 18.49
1 EGT
76–70–00
Page 30
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2
Cable ties
2 Locking plate
Step Procedure
2 Lay the wires of the EGT sensors.
3 Clean the thread of the temperature
sensor.
4 Apply LOCTITE ANTI SEIZE. to tempera-
ture sensor.
5 Use an SW 17 torque wrench (or similar
tool) and tighten the temperature sensors
with sealing plugs on the exhaust pipes.
Tightening torque 15 Nm (133 in lb.).
Figure 18.50
Exhaust pipe
1
Sealing ring
3
Step Procedure
6 Plug the respective wiring harness con-
nector into the corresponding pressure or
temperature sensor. See
00 section Wiring harness (main
Exhaust gas tempera-
2
ture sensor
Chapter 76-50-
strand).
Effectivity: 915 i A Series
Edition 0/Rev. 0