Fuel Pump Assy. - Removal - Rotax 915 i A series Maintenance Manual

Reduction sleeve - removal (if necessary)
• Loosen the hose clamp and remove the low pres-
sure hose.
• Loosen the clamps and remove the hose to inter-
cooler and air intake hose.
Figure 11.12
Hose clamp (low
1
pressure hose)
3 Reduction sleeve
5 Air intake hose
Figure 11.13
FUEL PUMP ASSY. — REMOVAL
Preparation
Drain the fuel.
See Maintenance Manual Line for the en-
gine type 915 i A Series, Chapter 12-20-00
section Planned maintenance.
• Remove the feed line to fuel rail 1/3 and the return
line to fuel rail 2/4 and fuel pressure regulator and
close them with the appropriate caps.
• Drain the fuel from the fuel pump and close it with
appropriate plug caps.
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Low pressure hose
2
Clamps (intercooler /
4
air intake)
6
Intercooler hose
Figure 11.14: Overview
Housing
1
3 Pressure line
NOTE
The position and type of positioning and attach-
ment of the fuel pump depends on the aircraft
type. See aircraft manufacturer documentation.
ENVIRONMENTAL NOTE
All the operating fluids and cleaning agents
can damage the environment if not disposed
of properly.
Dispose of operating fluids in an eco-friendly
manner!
Intake system
2
Fuel pump assy.
4
73–10–00
Page 15
August 01 2018