Installation; Needle Bearing - Installation - Rotax 915 i A series Maintenance Manual

INSTALLATION

NEEDLE BEARING — INSTALLATION
Step Procedure
1 Lubricate a new O-ring with engine oil
and push it into the crankcase with the oil
inlet flange.
NOTE
Ensure that the two M6 threads must be hori-
zontal and scavenge oil hole on upper position.
See following Figure.
Step Procedure
2 Install the governor flange with two
M6x20 Allen screws and the oil inlet
flange with two M6x16 Allen screws
lightly at first for better positioning. See al-
so Chapter 61–20–00.
Figure 6.67
Oil inlet flange
1
3 M6 threaded bores
72–10–00
Page 42
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
O-ring
2
4 Scavenge oil hole
Figure 6.68
Governor flange
1
3 M6x16 Allen screws
Step Procedure
3 Install the extractor part no. 877615 onto
the crankcase, place the press-in mush-
room part no. 276000 in the needle bear-
ing, put it on the centring and press it with
the spindle into the crankcase as far as it
will go.
NOTE
Lubricate needle bearing on outer
diameter.
2
M6x20 Allen screws
Effectivity: 915 i A Series
Edition 0/Rev. 0