Installation Of Propeller Gearbox - Rotax 915 i A SERIES Maintenance Manual

INSTALLATION OF PROPELLER GEARBOX

Preparation
• Clean and degrease all parts carefully.
• Remove LOCTITE adhesive residue with LOCTITE 7063.
• Visual inspection of the crankshaft on the power take off side.
Figure 5.6
Step
05–50–00
Page 8
December 01 2017
MAINTENANCE MANUAL
No hammering or pressing! The drive gear must only be pushed on manually.
Ensure that the friction washer is in the correct installation position.
The dog and drive gears are in pairs.
Only use parts with the same serial number.
Crankshaft (power take off side)
1
3 Friction washer VS-30
Procedure
1
Push the drive gear onto the crankshaft.
BRP-Rotax
ATTENTION
ATTENTION
ATTENTION
2
4
Drive gear
Hex. nut
Effectivity: 915 i A Series
Edition 0/Rev. 0