Rotax 915 i A series Maintenance Manual page 452

EXHAUST MANIFOLD ASSY. – REMOVAL
Step Procedure
1 Remove hex. nuts M8 with washers.
2 Remove Allen screws M8x20 and M8x30.
Figure 20.6
Exhaust manifold
1
assy.
Turbo charger
3
5 Washer 8.4
7 Allen screw M8x30
MUFFLER ASSY. — REMOVAL
Preparation
• Remove turbocharger before muffler assy. remov-
al, see Chapter 78-20-00 Turbocharger –
Step Procedure
1 Remove 3 hex. screws on the exhaust
bracket.
78–10–00
Page 6
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Turbo charger bracket
2
4
Hex. nut M8
6
Allen screw M8x20
removal.
Figure 20.7
Turbocharger
1
3 Hex. screws
NOTE
Studs M8 x 19.5/13 are for attaching the muffler
assy.. Check for tight fit and any damage.
When replacing a stud, it is fitted so that the lon-
ger thread (19.5 mm (.76 in.) is screwed into the
turbo. Apply LOCTITE ANTI SEIZE to studs.
Step Procedure
2 Remove hex. nuts with washers of the
muffler assy.
3 Remove turbocharger with turbocharger
bracket from the muffler assy.
Muffler assy.
2
4
Exhaust bracket
Effectivity: 915 i A Series
Edition 0/Rev. 0