Rotax 915 i A series Maintenance Manual page 62

Figure 2.6
1 Allen screw M5x45
OPS pressure sensor
3
(oil)
Step Procedure
5 Loosen plug screw M20x1.5.
Figure 2.7
Plug screw M20x1.5
1
with O-ring
Step Procedure
6 Loosen 5 Allen screws M6x30 and 2 Allen
screws M6x50 with washer 6.4.
7
Disconnect OPS pressure sensor.
24–20–00
Page 8
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2
Hex. nut M5
NOTE
The bore/thread of the Allen screws M6x50
(next to CPS_1) goes through to the crankcase.
To avoid leakage and loss of crankcase pres-
sure the screw is secured with LOCTITE 243.
Figure 2.8
1 Allen screws M6x30
Ignition housing assy.
3
Step Procedure
8 Remove Oil seal with a screwdriver.
9 Place the protection mushroom part no.
877419 on the crankshaft and use a pull-
er part no. 876010 to take off the ignition
housing.
NOTE
The ignition housing has one dowel pin.
2
Allen screws M6x50
4
Oil seal
Effectivity: 915 i A Series
Edition 0/Rev. 0