Rotax 915 i A series Maintenance Manual page 406

AIRBOX PRESSURE SENSOR AND
TEMPERATURE SENSOR —
CONNECTION
The sensors are connected and disconnected in the
same way. See Chapter 76-50-00 section
NOTE
Note the position of the 2 clamps.
Figure 17.30
1 Pressure sensors
3 Cable ties
KNOCK SENSOR — CONNECTION
The sensors are connected and disconnected in the
same way. See Chapter 76-50-00 section
CRANKSHAFT POSITION SENSOR —
CONNECTION
The sensors are connected and disconnected in the
same way. See Chapter 76-50-00 section
NOTE
•
CPS_1 for LANE A (upper crankshaft position
sensor)
•
CPS_2 for LANE B (lower crankshaft position
sensor)
76–50–00
Page 22
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Removal.
2 Clamps
Removal.
Removal.
NOTE
The sensors are identical, they are not labelled.
TEMPERATURE AND PRESSURE
SENSOR (OIL) — CONNECTION
The sensors are connected and disconnected in the
same way. See Chapter 76-50-00 section
THROTTLE POTENTIOMETER —
CONNECTION
The sensors are connected and disconnected in the
same way. See Chapter 76-50-00 section
PRESSURE SENSOR (BPS) –
CONNECTION
The sensors are connected and disconnected in the
same way. See Chapter
(BPS) - disconnection.
TEMPERATURE SENSOR CTS AND
INJECTOR — CONNECTION
ATTENTION
Do not clamp the cables for INJ_4 and CTS
(Coolant Temperature Sensor) together.
The sensors are connected and disconnected in the
same way. See Chapter 76-50-00 section
EGT CONNECTOR AND IGNITION COIL
— CONNECTION
The sensors are connected and disconnected in the
same way. See Chapter
unit. To be observed:
Removal.
Removal.
76-50-00 Pressure sensor
Removal.
74-20-00 section Ignition
Effectivity: 915 i A Series
Edition 0/Rev. 0