Assembly Of Crankshaft, Water Pump Shaft And Balance Shaft - Rotax 125 MAX evo Repair Manual

ASSEMBLY OF CRANKSHAFT, WATER PUMP SHAFT AND BALANCE SHAFT

Special tools The following special tools and equipment are required.
Instruction See
1. Coat main bearing seats of the crankshaft (1) with LOCTITE Anti-Seize.
2. Insert the crankshaft assy. (1) as shown on the picture into the crankcase half.
3. Coat bearing seats of the balance shaft (2) with LOCTITE Anti-Seize.
4. Insert the balance shaft (2) as shown on the picture into the crankcase half.
5. Insert the water pump shaft (3) as shown on the picture into the crankcase half.
6. Position new gasket (4) as shown on the picture into the crankcase half.
N N O O T T E E
Adjustment of the clearance of the crankshaft is not required.
Figure 5.31: Crankshaft, Balance shaft, Water pump shaft
______________________________________________________
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0
BRP-Rotax
REPAIR MANUAL
Part no.
n.a.
297434
Figure: Crankshaft, Balancs shaft, Water pump shaft
Crankshaft assy.
1
Water pump shaft
3
Description
Convection oven
LOCTITE Anti-Seize
2 Balance shaft
4 Gasket
Field of application
Case half
Balance shaft, crankshaft
Chapter 5
Page 35