Outbound Ip Filter - D-Link DSL-2641B User Manual

Section 3 – Configuration

Outbound IP Filter

By default, all outgoing IP traffic from the LAN is allowed. The Outbound Filter allows you to create a filter rule to block outgoing IP traffic by
specifying a filter name and at least one condition below. All of the specified conditions in this filter rule must be satisfied for the rule to take effect.
To access the OUTBOUND IP FILTER setting window, click on the Outbound Filter button in the ADVANCED directory.
ADD OUTBOUND IP FILTER
Enter the Filter name and at least one of the following criteria:
Protocol, Source/Destination IP Address and Subnet Mask, and
Source/Destination Port.
Click on the Add/Apply button to add and apply settings.
The Active Outbound IP Filter shows detailed information about each
created outbound IP filter. To remove an IP filter, click on the Remove
button (only appears when there is an existing IP filter).
D-Link DSL-2641B User Manual 47