Range - Allied Telesis x310-26FT Command Reference Manual

D H C
YNAMIC OST ONFIGURATION

RANGE

range
Overview This command adds an address range to the DHCP address pool you are
configuring. The DHCP server responds to client requests received from the pool's
network. It assigns an IP addresses within the specified range. The IP address range
must lie within the network. You can add multiple address ranges and individual IP
addresses for a DHCP pool by using this command multiple times.
The no variant of this command removes an address range from the DHCP pool.
Use the no range all command to remove all address ranges from the DHCP pool.
range <ip-address> [<ip-address>]
Syntax
no range <ip-address> [<ip-address>]
no range all
Mode DHCP Configuration
To add an address range of 192.0.2.5 to 192.0.2.16 to the pool
Examples
Nerv_Office, use the command:
awplus#
awplus(config)#
awplus(dhcp-config)#
To add the individual IP address 192.0.2.2 to a pool, use the command:
awplus(dhcp-config)#
To remove all address ranges from a pool, use the command:
awplus(dhcp-config)#
Related ip dhcp pool
Commands
service dhcp-server
show ip dhcp pool
C613-50103-01 REV A
P (DHCP) C
ROTOCOL OMMANDS
Parameter
<ip-address>
configure terminal
ip dhcp pool Nerv_Office
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
IPv4 address range for DHCP clients, in dotted decimal
notation. The first IP address is the low end of the range, the
second IP address is the high end. Specify only one IP address
to add an individual IP address to the address pool.
range 192.0.2.5 192.0.2.16
range 192.0.2.2
no range all
2217