Service Dhcp-Relay - Allied Telesis x310-26FT Command Reference Manual

D H C
YNAMIC OST ONFIGURATION
-
SERVICE DHCP RELAY

service dhcp-relay

Overview This command enables the DHCP Relay Agent on the device. However, on a given
IP interface, no DHCP forwarding takes place until at least one DHCP server is
specified to forward/relay all clients' DHCP packets to.
The no variant of this command disables the DHCP Relay Agent on the device for
all interfaces.
service dhcp-relay
Syntax
no service dhcp-relay
Mode Global Configuration
Usage A maximum number of 400 DHCP Relay Agents (one per interface) can be
configured on the device. Once this limit has been reached, any further attempts
to configure DHCP Relay Agents will not be successful.
Default The DHCP-relay service is enabled by default.
Examples To enable the DHCP relay global function, use the commands:
awplus#
awplus(config)#
To disable the DHCP relay global function, use the commands:
awplus#
awplus(config)#
Related ip dhcp-relay agent-option
Commands
ip dhcp-relay agent-option checking
ip dhcp-relay information policy
ip dhcp-relay maxhops
ip dhcp-relay server-address
C613-50103-01 REV A
P (DHCP) C
ROTOCOL OMMANDS
configure terminal
service dhcp-relay
configure terminal
no service dhcp-relay
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
2219