JEOL JSPM-5200 Instructions Manual page 87

５ MEASUREMENT OPERATION
4. 4.
Adjust the ve Adjust the ve
positioned at the center of the display. positioned at the center of the display.
■ Other settings ■ Other settings
CH1, CH2
TIME/DIV:
Trigger
VARIA
HOLD OFF:
■ Setting the software ■ Setting the software
You can select the signals that you want to monitor in CH2 using the software as follows: You can select the signals that you want to monitor in CH2 using the software as follows:
1. 1.
Click on Click on
The SPM Parameters window will appear.
2.
Click on the Advanced tab at the top of the SPM
The Advanced mode tab window appears.
3.
Click on the Status button at the lower left of the tab window.
The SPM Status window appears.
4.
Click on the Output
5-24
rtical position control knob ( ⇕ ) of CH2 so that the trace is rtical position control knob ( ⇕ ) of CH2 so that the trace is
VO LTS/DIV: 5 V/div
AC, GND, DC: DC
Mode: CHOP
2 ms/div
coupling: A C
BLE: C AL
NORM
the the measurement icon " measurement icon "
button; then select the desired signal for monitoring.
VARIABLE: Push in, CAL
NORM, AUTO:
Trigger source:
Internal trigger source:
LEVEL:
".
Parameters window
AUTO
INT
VERT
FIX
.
TMPM5200-2