JEOL JSPM-5200 Instructions Manual page 209

５ MEASUREMENT OPERATION
11.
Click on the Display Source tab, and then check the TOPO—Autoset box.
The "□" or " " checking bo
changes alternately between "□" and " ".
The " " checking box means th
■ Setting
Software Oscilloscop
Set Channel B following the pro
1.
Click on the " 2 " but
The Oscilloscope Control
2.
Click on the
then
5-146
e
ton of the Oscilloscope Control window.
window will open.
button in the Source selection box in the Channel B frame;
select Log Current from the pull-do
x is a toggle switch, and every time you click on it, it
at it is selected.
cedure below.
wn menu.
TMPM5200-2