JEOL JSPM-5200 Instructions Manual page 186

■ Observation of viscoelasticity image (optional measurement)
You can perform viscoelasticit
Extended Lock-in Amplifier. When the lock-in amplifier is connected to the SPM
controller, you have to set the instrument using the software to display the tab window
for viscoelasticity measurement.
Observation of a topography imag
Observe a topography image of the specimen surface, and confirm that you can obtain an
optimum image. Then retract the tip.
Setting Lock-in Amplifier
Set the lock-in amplifier as you did in Sect. 5.5.2 when you observe an image in the
v iscoelasticity measurement tab window.
Obs ervation of an image
1.
Carry out a topography image observation according to the usual method.
Confirm that you can observe well the AFM topograp
2.
Whe
follo
a.
Se
b.
Select VE-A
c.
Set Display Source to the following.
TMPM5200-2
n scan is finished, specify parameters according to the settings of the
wing SPM Parameters window.
lect 4 Inputs from Acquisition.
FM from Mode.
y measure men t by a dditionally installing the optional
e
５ MEASUREMENT OPERATION
hy image.
5-123