JEOL JSPM-5200 Instructions Manual page 248

not check it (forwar
forward scan image and the backward scan image at the same time.
• So
urce Gain
Set the source-signal gain for the TOP
urement signal. You
you cannot obtain enough contrast in the measurement image such as an atomic
image obse
l arge region or with a very bumpy surface, the source signal might becom
rated. Usuall
obtain enou
Conta ct AFM tab window
• Source 1, 2
Select the signal sources for images. The selection of signals also affects the
number of source signals. You must select either Topography or Force for source
signal 1, and either Topography, Force or None for source signal 2. The relation
between source signals and the number of measurement images is the same as that
in the AC-AFM tab window.
• BW
Same as that in the AC-AFM tab window.
• Source Gain
Same as that in the AC-AFM tab window.
• AFM
When you perform normal measurement, select this radio button. Measurement
settings follow the current settings.
TMPM5200-2
d scan) to the other display source, then you can obtain the
can set 6 steps from 1 to 32 for the gain. You use them when
rvation. If you set a high gain when you observe such specimens with a
y, observe under low gain and increase the gain when you cannot
gh contrast.
The setting here does not a
If the Enable Pre-Scan check box is ch
obtain the optimum gain from the result of
５ MEASUREMENT OPERATION
O signal (shape signal) using it as a meas-
ffect feedback operations.
ecked, the system will automatically
Pre-Scan.
e satu-
5-185