JEOL JSPM-5200 Instructions Manual page 176

The Tip window will close and
to the Display Window; then, the cursor changes to a hand mark.
6.
Move the cursor to the cantilever position (+); then, drag it, while holding
d own the left mouse button, to the point where you want to measur
Force Curve.
The cantilever is actually moving in real time during the cursor dragging, so be sure
to drag the + mark slowly enough.
7.
After placing the + mark a
button to finalize the position.
The Tip window will appear again.
8.
Deselect Tip Retract.
9.
Click on the
If you changed the measurement point by this method, the changed point becomes
the initial position for
or Ab
TMPM5200-2
Cantilever position
Repeat button on the Advanced tab window.
the cantilever. So
ort has be en perf ormed, the cantil
the Tip position window will open. Move the cursor
Mouse cursor
Force Cu
m easur
point
t the measurement point, press the right mouse
, when the me
ever tip return
５ MEASUREMENT OPERATION
rve
ement
asurement has be en completed
s to this initial posit ion.
e the
5-113