JEOL JSPM-5200 Instructions Manual page 120

■ Setting the
software oscilloscope
Set the software oscilloscope for Channel B as follows:
1.
lick on the 2 button of the Oscilloscope Control window.
C
The Oscilloscope Control window will open.
2 .
Click on the
then select Force from the pull-down menu.
3.
Click on the
frame; then select 5 from the pull-down menu.
TMPM5200-2
button in the Source selection box in the Channel B frame;
button in the Sensitivity selection box in the Channel B
５ MEASUREMENT OPERATION
5-57