JEOL JSPM-5200 Instructions Manual page 275

５ MEASUREMENT OPERATION
3 .
The Grab & Repeat dialog box
m easurements (up to 99 measurements).
4.
C lick on the OK button.
Continuous measurement starts.
Noise
Click ing on this button measures the voltage input to the AC converter 5,000 times a
s econ d, and displays the minimum, m
function is applicable onl
monitor of
the present position without performing measurement operations involving the scanner
movement.
The measurement procedure is as follows:
1.
Click o
ters window.
The SPM Status window opens.
2.
Select a source signal to the AD converter from source signals 1 to 4 in the
Display Source frame.
3.
Click on the Noise button in the Scan frame of the SPM Parameters window.
The SPM Stat
specified in the Display Source signal input boxes.
4.
If you want to stop noise
Paus e
When you click
present position. To restart scanning, click on
restarts from that positio
Abort
When you click on this button, scanning is stopped and the tip returns to the initial
position.
5-212
Continuously measured images are automatically stored in the selected folder.
A serial measurement number is automatically attached to the filename.
Example: Filename test → test00.tif, test01.tif...
y when the Status Display window, which is also a signal
the AD converter, appears. During noise measurement, the scanner stays at
n the Status button in the Display Source frame of the SPM Parame-
us window displays the result of noise measurement of the signals
measurement, click on the Abort button.
on this button, scanning is temporarily stopped and the tip stays at the
n.
appears. Enter the number of continuous
aximum and mean values of the voltage. This
the Repeat or Single button. Scanning
TMPM5200-2