JEOL JSPM-5200 Instructions Manual page 190

3.
Click on the A
Source tab in the Advanced Control window that appears. Set parameters as
follows.
4.
Select the Scan tab in the Advanced Control window, and then check the Add
External Y Signal check box.
5.
Click on the Probe button in the SPM Parameters window, and the Tip
window opens; then deselect the Tip Retract button.
TMPM5200-2
dvanced button in the Advanced tab window. Select Display
Sometimes an oscillating sound is made depending upon the characteristic
frequency of the scanner that you use. If it happens, reduce the oscillation level
(OSC Level/V), or shift the present oscillation frequency (OSC Fre-
quency/kHz) setting position until the sound is not made.
５ MEASUREMENT OPERATION
5-127