JEOL JSPM-5200 Instructions Manual page 79

５ MEASUREMENT OPERATION
Setting software (Model 5110)
1.
Click on SPM Scan in the main menu bar to open the pull-down menu; then
click on Device Setup to open the Device Setup dialog box.
2.
Check the Lock-in Amplifier box and click on the Model 51110 radio button.
■ Descri
ption of the lo
Layo ut of the front operation panel
①
②
① "A" terminals
Cursor keys
②
③ Cursor keys
Function keys
④
⑤ OSC OUT terminals
Setting (Mod
The RS − 232C is
should occur
procedur
5-16
ck-in ampli fier (Model 7265)
el 7265) RS -232C of
adjusted and set before shipment from the factory. However, if an error
when you are operating the lock-in amplifier, perform the following
e:
Signal input terminals
Cursor keys to set parameters
Cursor keys to set parameters
Keys to select the set p arameters
Modulation oscillator output terminals
Lock-in Amp lifier
③ ⑤
④
TMPM5200-2