Table of Contents
Advertisement
(3) Install the bearing caps and rocker shafts. Tighten
them to the specified torque.
Tightening Torque
M10 Bolt:
M8 Bolt:
12.7 - 16.7 N·m/Dry
NOTE:
•
Each bearing cap bears a cap number.
•
The intake valve rocker shaft can be identified by the
recessed sections on it.
•
The valve rocker shaft should be installed in such a di-
rection that the side having a wider chamfer comes at
the timing belt side.
•
Ensure that the bolt holes and bolts are dry when tight-
ening the bolts. (Ensure that no oil or the like gets to
the bolt holes and bolts.)
(4) Remove the bearing caps and measure the oil clear-
ance.
Clearance
Specified Value:
Allowable Limit:
If the oil clearance exceeds the allowable limit, replace
the cylinder head and camshaft as a set.
NOTE:
•
After completion of the check, remove the plastigages.
Wash the camshaft and bearing caps in cleaning sol-
vent.
9. Inspection of camshaft thrust clearance
(1) Apply engine oil to the camshaft journals.
28.4 - 36.3 N·m/Dry
0.035 - 0.076 mm
0.17 mm
EM–35
JEM00133-00120
JEM00134-00121
JEM00135-00122
Advertisement
Table of Contents
