Table of Contents
Advertisement
4. Inspection of tension spring
(1) Check the free length of the spring
Free Length:
(2) Check the tension of the spring at the specified instal-
lation length.
Specified Value:
29.4 ± 3 N at 50.9 mm
If the tension does not conform to the specification, re-
place the spring.
5. Inspection of crankshaft timing belt pulley and flange
(1) Measure the maximum width of the timing belt pulley,
using vernier calipers.
Wear Limit of Crankshaft Timing Belt Pulley:
If the measured value is less than the specified value,
replace the timing belt pulley with a new one.
(2) Visually inspect the crankshaft timing belt pulley for
damage. If any damage is present, replace the crank-
shaft timing belt pulley.
(3) Visually inspect the crankshaft timing belt pulley flange
for bend, wear and other damage.
If any damage is present, replace the crankshaft tim-
ing belt pulley flange.
INSTALLATION
1. Installation of camshaft timing belt pulley
(1) Install the camshaft timing belt pulley on the camshaft
in such a way that the "F" mark can be seen and the
locating pin hole is aligned.
46.5 mm or less
59.3 mm
EM–17
JEM00054-00044
JEM00055-00045
JEM00056-00046
JEM00057-00047
JEM00058-00000
Advertisement
Table of Contents
