Table of Contents
Advertisement
(7) Apply the ATF to the outer periphery of the stator shaft
& oil pump assembly.
(8) Install the stator shaft & oil pump assembly to the
transmission case.
NOTE:
•
Be very careful not to damage or twist the O-ring dur-
ing the installation of the stator shaft & oil pump as-
sembly.
(9) Tighten the seven bolts of the stator shaft & oil pump
assembly.
Tightening Torque:
NOTE:
•
Be sure to tighten the bolts alternately and diagonally.
(10) Measure the input shaft end play with a dial gauge
and the following SST.
SST:
09351-87210-000
Specified Value:
NOTE:
•
If the measured end play exceeds the specified value,
remove the stator shaft & oil pump assembly and the
direct clutch from the transmission case. Then, select
the thickness of the thrust bearing race from the right
lower table. Proceed to perform the operations of the
steps from 21-(2) to 23-(10).
6.9 - 9.8 N·m (0.7 - 1.0 kgf-m)
0.28 - 0.92 mm
Thrust Bearing Race Availability
Thrust bearing race
thickness
Unit: mm
1.55 - 1.65
1.95 - 2.05
2.35 - 2.45
AT–79
JAT00227-00202
JAT00228-00203
JAT00229-00204
Part No.
35789-87208-000
35789-87209-000
35789-87210-000
JAT00230-00000
Advertisement
Table of Contents
