Table of Contents
Advertisement
(3) Tighten the flywheel attaching bolts to the specified
torque in the sequence indicated in the right figure.
Tightening Torque:
NOTE:
•
Prevent the crankshaft from turning at the ring gear
section, using the following SST.
SST:
09210-87701-000
CAUTION:
•
When tightening the bolt, make sure that no bond is
present on the bolt seating surface.
If the bond oozes out, perform the operations again,
starting the step (2).
(4) Tighten the flywheel attaching bolts to the specified
torque in the sequence indicated in the right figure.
Tightening Torque:
(5) Measure the flywheel runout, using a dial gauge.
Allowable Runout Limit:
NOTE:
•
Replace the flywheel if its runout exceeds the allowable
limit.
10. Installation of drive plate
(A/T vehicle only)
(1) Application of flywheel bolt sealing material
q Wash the flywheel bolts. Then, degrease and dry them.
NOTE:
•
When degreasing the bolts, remove any oil completely, using a solvent such as a degreasing spray-
ing agent or alcohol.
CAUTION:
•
Make sure that no bond nor other foreign matter, such as dust, gets to the bolts.
•
Even when new bolts are used, be sure to perform this operation.
w Check the flywheel bolts for damage. Replace any flywheel bolt which exhibits damage with a
new one.
CAUTION:
•
Even when a new bolt is used, be sure to perform the operation in the step (1).
e Clean the flywheel bolt threaded holes at the rear end section of the crankshaft. Degrease and
dry them.
CAUTION:
•
Make sure that no bond nor other foreign matter, such as dust, gets to the bolt threaded holes.
•
As for degreasing, wipe off any oil from the threaded portion with a cloth damped with alcohol.
44.1 - 63.7 N·m
78.5 - 98.0 N·m
0.1 mm
EM–107
q
t
r
e
w y
JEM00454-00410
JEM00455-00411
Advertisement
Table of Contents
