Daihatsu 1997 Terios J100 Service Manual page 563

FS–10
INSTALLATION
1. Press the front axle hub into the steering knuckle sub-as-
sembly using the following SST in combination with hy-
draulic press.
SST: 09559-10010-000, 09252-10010-000 (Use the
09550-10012-000 that is a part of the set.)
NOTE:
·
Press in the steering knuckle into the axle hub after the
axle hub placed on the SST 09506-87302-000.
2. Install the steering knuckle after insert the drive shaft to
the steering knuckle as follows.
(1) Connection of shock absorber to steering knuckle
q Connect the steering knuckle on the shock ab-
sorber lower bracket.
w Install the new bolts and nuts, then tighten the
bolts and nuts to specified tightening torque.
Tightening Torque:
CAUTION:
·
Be sure to tighten the attaching nuts when tightening.
(2) Connection of tie-rod end to steering knuckle
q Connect the tie-rod end to the steering knuckle
with the castle nut. Then, tighten the castle nut to
specified tightening torque.
Tightening Torque:
w Install the clip to the castle nut.
CAUTION:
·
Never adhere a grease or oil, etc. to the taper section
of the lower ball joint.
·
Never make any damage on the dust cover of the ball
joint.
(3) Connection of suspension lower arm to steering
knuckle
q Connect the suspension lower arm to the steering
knuckle with the castle nut. Then, tighten the castle
nut to specified tightening torque.
Tightening Torque:
w Install the clip to the castle nut.
CAUTION:
·
Never adhere a grease or oil, etc. to the taper section
of the lower ball joint.
·
Never made any damage on the dust cover of the ball
joint.
3. Install the sensor mounting bracket with the skid control
sensor to the steering knuckle.
Tightening Torque:
101.9 - 152.9 N·m
(10.4 - 15.6 kgf-m)
39.2 - 53.9 N·m (4.0 - 5.5 kgf-m)
44.1 - 58.8 N·m (4.5 - 6.0 kgf-m)
6.9 - 9.8 N·m (0.7 - 1.0 kgf-m)
JFS00031-00031
JFS00032-00032
JFS00033-00033
JFS00034-00034
JFS00035-00035