Table of Contents
Advertisement
BE–56
STEERING WHEEL PAD (AIR BAG UNIT FOR THE DRIVER) & STEERING ROLL
CONNECTOR
COMPONENTS
r
REMOVAL
1. Turn off the ignition switch and detach the negative (–) ter-
minal of the battery cable from the battery terminal.
2. Set the steering wheel to a straight-ahead position.
Remove the attaching bolts (TORX
sides of the steering wheel cover side.
WARNING:
·
Be sure to start the operation 60 seconds after the
power supply is cut off. Failure to observe this warning
may cause unexpected deployment of the air bag
owing to impacts, etc. during the removal.
·
Never bring your face, arms and body to the front of
the steering wheel during the removal.
·
If the pad assembly is dropped or damaged during the
removal or the storage, be sure to dispose of the pad
assembly according to the disposal procedure. Be sure
to mount a new pad assembly to the vehicle.
CAUTION:
·
It should be noted that, when the negative (–) terminal
of the battery is detached, the memory of the ECU con-
trol of the other system will be erased at the same time.
3. Separate the pad assembly and steering wheel.
Disconnect the connector for the air bag and connector
for the horn provided at the reverse side of the pad as-
sembly.
WARNING:
·
Never resume the operation within 60 seconds after
the power supply has been cut off, during which the
backup condenser is discharged.
e
w
S
®
) at the right and left
w
q Steering wheel pad assembly
w Steering wheel pad set plate
e Steering wheel
r Steering wheel cover
IG "OFF"
q
JBE00182-05019
JBE00183-05020
JBE00184-05021
JBE00185-05022
Advertisement
Table of Contents
