Daihatsu 1997 Terios J100 Service Manual page 791

DISASSEMBLY
Removal of rear door trim panel assembly
1. Unlock the shaft snap ring of the rear door window regula-
tor handle assembly by inserting a piece of cloth between
the rear door window regulator handle and the door vent
window control handle plate. Then, pull the inserted cloth
alternately so as to unlock the shaft snap ring.
2. Remove the rear door window regulator handle, shaft
snap ring and door vent window control handle plate.
3. Remove the attaching screws of the rear door inside han-
dle assembly.
4. Unscrew the rear door locking button.
5. Remove the door pull handle by removing the attaching
screw.
6. Disengage the retainers provided on the back side of the
rear door trim panel assembly.
7. Unlock the nail section of the rear door inside handle sub-
assembly from the rear door panel. Then, insert it into the
rear door trim panel assembly.
8. Remove the rear door trim panel assembly from the rear
door panel by hang it off.
9. Remove the door trim No.1 bracket by removing the at-
taching bolts.
10. Remove the rear door inside handle subassembly by dis-
connecting it from the rear door open control link assem-
bly.
11. Remove the rear door service hole cover from the rear
door panel.
CAUTION:
·
Never reuse the removed service hole cover.
12. Remove the rear door glass weatherstrip assembly from
the rear door trim panel assembly by straightening the
protrusion section on the rear door glass weatherstrip as-
sembly.
13. Remove the door control knob holder from the door trim
panel panel assembly.
BO–53
JBO00134-00113
JBO00135-00114
JBO00136-00115
JBO00137-00116
JBO00138-00117