Table of Contents
Advertisement
BR–86
ABS ECU
COMPONENTS
q Glove compartment subassembly
w Skid control computer assembly
8.3 ± 1.4 (0.85 ± 0.15)
B
CAUTION:
·
Be sure to read out the diagnosis code of the ABS and
EFI systems before disconnecting the battery power
supply. Failure to observe this caution will erase the
memorized diagnosis codes.
·
Be sure to perform the unit inspection of the ABS ECU
at the battery voltage between 10 to 14 volts when the
ignition switch is turned ON.
·
Use correct measuring instrument for inspection.
(Refer to BR–42.)
1. Disconnect the negative terminal of the ground cable from
the negative terminal of the battery.
2. Remove the glove compartment box by removing the re-
tainer. (Refer to BO section.)
3. Disconnect the connector of the wire harness from the
ABS ECU.
4. Connect the following SST between the ABS ECU and the
connector of the wire harness.
SST:
09842-87401-000
5. Connect the negative terminal of the ground cable to the
negative terminal of the battery.
6. Measure the voltages under the condition specified in the
table below and perform the trouble shooting of the part(s)
related to the wire harness and connection as mentioned
in the table below.
NOTE:
·
All specifications mentioned in the following table de-
note values at a temperature under 20-25 °C.
·
Be sure to perform the trouble shooting including its re-
lated wire harness and connectors of presumable parts
mentioned in the following table.
B
w
B
8.3 ± 1.4 (0.85 ± 0.15)
: Tightening torque
Unit : N·m (kgf-m)
q
JABS00123-00064
JABS00124-00000
JABS00125-00065
Advertisement
Table of Contents
