Table of Contents
Advertisement
ASSEMBLY
NOTE:
•
Wash those parts to be assembled in cleaning solvent.
Dry them using compressed air.
WARNING:
•
When you use compressed air, be sure to protect your
eyes, wearing goggles.
1. Apply engine oil to the relief valve. Then, insert the relief
valve into the oil pump body.
2. Insert the compression spring and retainer into the oil
pump body.
CAUTION:
•
Install the retainer in such a direction that its projected
side may come at the compression spring side.
3. Insert a new cotter pin into the retainer while the retainer is
being compressed with pliers, etc. Split the end of the cot-
ter pin to form an anchor-like shape.
4. Drive a new oil seal into position if the oil seal exists dam-
aged, using a hydraulic press.
NOTE:
•
Be very careful not damage the oil pump during the re-
moval and the installation of the oil seal.
•
Make sure that the oil seal is not driven into position in
a tilted state.
5. Apply engine oil to the rotor set. Assemble the rotor set in
the pump body in such a direction that the drilled mark of
the rotor may be seen from the outside.
LU–7
JLU00024-00411
JLU00025-00412
JLU00026-00413
JLU00027-00414
Mark
JLU00028-00415
Advertisement
Table of Contents
