Daihatsu 1997 Terios J100 Service Manual page 185

EM–124
ENGINE MECHANICALS
Timing belt pulley
Timing belt tension spring
Camshaft
Cylinder head
Valves
Wear limit Camshaft
Crankshaft
Free length
Installation load
Oil clearance
(Cylinder head to camshaft)
Maximum limit
Thrust clearance
Maximum limit
Fuel pump cam diameter
Minimum
Fuel pump cam stroke
Standard
Minimum
Valve cam lobe height
Intake
Exhaust
Minimum limit
Intake
Exhaust
Maximum circle run out
Warpage Cylinder block side
Intake manifold side
Exhaust manifold side
Valve seat angle Intake
Exhaust
Valve contacting angle
Valve seat contacting width
Standard
Allowance
Maximum valve seat recession
(Depth measured from cylinder head gas-
ket attaching surface to uppermost part of
a new valve inserted into position)
Intake
Exhaust
Valve stem diameter Intake valve
Exhaust valve
Valve length Intake valve
Exhaust valve
Valve face angle
Valve stock thickness (Minimum)
Intake
Exhaust
Valve stem oil clearance
Intake Standard
Maximum
Exhaust Standard
Maximum
119.8 mm
59.3 mm
46.5 mm
29.4 ± 3 N at 50.9 mm (3.0 ± 0.3 kg at 50.9 mm)
0.035 - 0.076 mm
0.17 mm
0.1 - 0.25 mm
0.45 mm
42.65 mm
5.0 mm
4.8 mm
33.434 - 33.634 mm
33.17 - 33.37 mm
33.2 mm
33.0 mm
0.03 mm
0.10 mm
0.10 mm
0.10 mm
30° - 45° - 70°
20° - 45° - 70°
45°
1.4 mm
1.2 - 1.6 mm
0.5 mm
2.775 mm
6.026 mm
6.560 - 6.580 mm
6.555 - 6.575 mm
112.8 mm
114.5 mm
45.5°
0.8 mm
1.0 mm
0.030 - 0.055 mm
0.080 mm
0.035 - 0.060 mm
0.090 mm