Table of Contents
Advertisement
BR–46
DIAGNOSIS CODE CHECK
1. Checking of ABS warning lamp
(1) Ensure that the ABS warning lamp will glow for about
three seconds after the ignition switch is turned ON,
and, then, the warning lamp goes out.
NOTE:
·
Proceed to trouble shooting according to the trouble
phenomenon if the ABS warning lamp fails to meet the
condition above.
2. Output of diagnosis codes
(1) Remove the inspection diode from the connector.
(2) Connect the following SST to the diagnosis connector.
SST:
09991-87401-000
(3) Connect the ECUT and GND terminals in the SST with
the following SST.
SST:
09991-87403-000
CAUTION:
·
Never connect the terminal other than that specified.
Even slight contact of the other terminals causes serius
malfunction.
(4) Turn ON the ignition switch.
(5) Read out the diagnosis code(s) by observing the num-
ber of blinking of the ABS waning lamp.
NOTE:
·
When plural malfunctions codes are memorized, the
code will be outputted starting from a smaller code
number at intervals of 2.5 seconds.
·
After completion of one cycle, the same codes will be
outputted again at intervals of 4 seconds.
Single code : 11
0.5
ON
OFF
1.5
4
Normal code
OFF
Plural code : 11 and 13
ON
OFF
0.5
4.0
1.5
2.5
O/D
OFF
ON
0.25
0.25
1.5
JABS00011-00006
JABS00012-00007
ECUT
GND
JABS00013-00008
Unit : Second
JABS00014-00009
4.0
unit : Second
JABS00000-00010
Advertisement
Table of Contents
